Cathode Lighting Systems FCLS-Slim Instrukcja Użytkownika Pobierz pdf (Strona 3)

Installation Manual Page 3

8020 Queenair Drive, Gaithersburg, MD 20879 USA • phone: 301 921 4120 • fax: 301 963 3050

email: [email protected] • website: www.CathodeLightingSystems.com

FCLS-Slim Manual 8-11

PREPARING THE LUMINAIRE FOR INSTALLATION

Luminaires are shipped pre-assembled from the factory. The only field preparation required is that the pryouts at

the end of each luminaire must be removed and the quick-connect wiring inside must be withdrawn so that it may

be connected to the pre-assembled jumper cables. In some instances, a luminaire (or array of luminaires) will

terminate, and no wiring will be required into the last enclosure. The pryouts are intended to be left undisturbed in

these situations.

Step No. 1:

Remove pryout

Step No. 2:

Remove snap-on cover, discard

pryout slug and careully feed the

three quick connect terminals and

wire through the open hole

Step No. 3:

Replace snap-on cover

Pryouts are to be left in

place if no wiring is required

into the end of a luminaire

1 2 3 4 5 6 7 8 9 10 11

Brak uwag

Cathode Lighting Systems FCLS-Slim Instrukcja Użytkownika Strona 3